Propagation guide

How to propagate Philodendron Selloum (Tree Philodendron) (Philodendron bipinnatifidum (syn. Thaumatophyllum bipinnatifidum, P. selloum)) — step by step

Also called Tree philodendron, Selloum, Lacy tree philodendron, Horsehead philodendron, Hope philodendron, Split-leaf philodendron.

The best way to propagate philodendron selloum (tree philodendron)

The reliable, beginner-friendly way to propagate philodendron selloum (tree philodendron) is nodal stem cuttings in water or soil. It suits this species because of how it grows: a large, non-climbing, self-heading aroid that forms a rosette of huge, deeply pinnatifid (lobed) leaves on long stalks radiating from a thickening semi-woody trunk. with age it develops a sprawling, almost tree-like form and prominent aerial roots. it spreads wide rather than tall indoors, so allow generous floor space.. Best propagated by division of the offsets (pups) that form at the base of mature plants: unpot, separate a clump with roots and at least one stem using a clean sharp knife, and pot each section into fresh moist compost. Stem cuttings with two or three nodes can also be rooted in water or compost over a few weeks. Mature plants set seed, but division is far faster and more reliable for home growers.

For the wider picture of which technique suits which plant, our guide to plant propagation methods compares water, soil, leaf, division and offset propagation side by side. Because philodendron selloum (tree philodendron) is an aroid, the same nodal-cutting technique shown in our step-by-step pothos propagation walkthrough transfers almost directly.

Step-by-step: propagating philodendron selloum (tree philodendron)

Find a node. Locate a node on a healthy philodendron selloum (tree philodendron) vine — the small bump where a leaf or aerial root meets the stem. New roots only emerge from nodes, so every cutting must contain one.
Take the cutting. With clean, sharp scissors cut about 1 cm below the node at a slight angle. Aim for a 10–15 cm cutting with 2–3 nodes and one or two leaves at the top.
Strip lower leaves. Remove leaves from the bottom node(s) so the bare nodes can sit in water or soil. A submerged leaf rots and fouls the water.
Root it. Stand the cutting in a glass of room-temperature water with the node(s) covered, or push it into moist potting mix. Place in bright indirect light. Change the water every 4–5 days.
Pot up. When the new roots are 3–5 cm long (usually 2–4 weeks), pot the cutting into a small container of rich, free-draining aroid mix and keep it slightly moister than normal for the first fortnight.

The alternative method

If the main route does not suit your plant or setup, soil propagation (skip the water glass) is the next best option for philodendron selloum (tree philodendron). Push the nodal cutting straight into moist potting mix instead of water — the roots that form are soil-adapted from day one, so there is no transition shock, though you cannot watch progress through the glass.

Timeline to roots

Realistically: roots in 2–4 weeks; pot up at 4–6 weeks. These numbers assume spring or summer warmth and bright indirect light. In a cold, dark room — or in winter dormancy — the same philodendron selloum (tree philodendron) propagation can take twice as long or stall completely, so do not panic if progress looks slow out of season. Patience beats poking: disturbing a forming root system to “check” on it is a common way to set it back.

Common failure points

Taking a cutting with no node — leaves alone never root, no matter how long they sit in water.
Letting the water go stagnant; refresh it every 4–5 days or the cut end slimes and rots.
Potting up water-rooted cuttings too late — long, brittle water roots struggle to adapt to soil. Move them at 3–5 cm.
Propagating off a stressed, pest-ridden or recently-repotted philodendron selloum (tree philodendron) — always take material from a healthy, established parent.

When to do it

The best window is spring and summer (active growth). Propagation is energetically expensive for a plant, and it only has the spare resources to build new roots when it is already growing actively, warm and well-lit. Out-of-season attempts are not pointless, but expect lower success and a longer wait.

Aftercare

For the first two to three weeks after potting, keep the new philodendron selloum (tree philodendron) slightly moister than you would a mature plant and out of direct sun while the young roots adapt from water (or cutting medium) to soil. Hold off all fertiliser until you see a flush of new top growth — feeding a rootless cutting only burns it. Match the parent's needs as the new philodendron selloum (tree philodendron) settles: Wants bright, filtered light and resents both deep shade and harsh midday sun. An east- or west-facing window with sheer-curtain protection is ideal, while the RHS advises partial shade and screening from intense glare under glass. Direct summer sun scorches the leaves; too little light gives weak, leggy growth and smaller, less-divided foliage.

Philodendron Selloum (Tree Philodendron) propagation — frequently asked questions

What is the best way to propagate philodendron selloum (tree philodendron)?

Nodal stem cuttings in water or soil is the most reliable method for philodendron selloum (tree philodendron). The best way to propagate philodendron selloum (tree philodendron) is a stem cutting taken just below a node. A cutting must include at least one node — the leaves alone will not root. Place the node in water or moist soil in bright indirect light. Roots appear in 2–4 weeks; pot up at 4–6 weeks.

Do you need a node to propagate philodendron selloum (tree philodendron)?

Yes — absolutely. Roots only emerge from a node, so every philodendron selloum (tree philodendron) cutting must include at least one. A length of stem or a leaf with no node will sit in water indefinitely and never root.

How long does it take philodendron selloum (tree philodendron) to root?

Roots in 2–4 weeks; pot up at 4–6 weeks. Timing varies with warmth and light — propagations move fastest in spring and summer when the plant is in active growth, and can stall almost completely in a cold, dark winter.

What is the best time of year to propagate philodendron selloum (tree philodendron)?

Spring and summer (active growth). Root and shoot development is metabolically demanding, so propagating during the active growing season gives noticeably higher success rates and faster results than attempting it in dormancy.

Can you propagate philodendron selloum (tree philodendron) in water?

Yes — philodendron selloum (tree philodendron) roots readily in a glass of water as long as a node is submerged. Water propagation is the most beginner-friendly route; just move the cutting to soil before the water roots get long and brittle (around 3–5 cm).